Open-plan living and dining area: One radiator or two?
Large, open spaces need warmth in the right places. Here’s how to find out whether one large radiator is enough or whether two smaller ones will heat the room more effectively.

In short: One radiator in an open living area is sufficient if the room is compact and the windows are on one side. If the area is long, L-shaped, or has windows on multiple sides, two radiators usually distribute the heat more evenly. In both cases, the basis is the heat demand of the entire area.
When the heating comes back on in autumn, an open-plan layout quickly reveals its peculiarities. It is comfortable on the sofa, but there is a draft at the dining table in front of the patio door. Or the kitchen corner remains cool, even though the radiator at the other end is working hard.
This is rarely due to insufficient power, but rather to distribution. An open living and dining area is a large room with several zones for the heating system. If you take this into account during planning, you will be warm everywhere later.
First determine the heat demand of the entire area
Before you think about the number and position, you need a figure: How much heat does the entire open area need? It depends on the area, ceiling height, insulation, window areas, and the desired temperature. You count living, dining, and cooking as one room, because the air circulates freely.
Only when this total is fixed do you distribute it among one or more radiators. Important: Together they must meet the demand, at the same temperatures at which your heating system operates. You estimate the heat demand with our heat load calculator; a professional heating company is responsible for an accurate calculation.
Where an open living area loses heat
Heat is not lost evenly. The greatest losses are at windows, patio doors, and exterior walls. At large glass surfaces, the air cools down, sinks, and flows as a cool draft over the floor into the room. That is exactly where it often feels uncomfortable, for example at the dining table.
A radiator under or next to the window counteracts this draft. The warm air rises along the cold surface and intercepts the falling cold. Therefore: If your open area has windows on two sides, there is a good reason to plan heat on both sides as well.
Interior areas without an exterior wall, on the other hand, need little heating surface of their own. Here, the heat coming over from the other zones is often sufficient.
An open staircase or gallery changes the calculation additionally. Warm air rises and draws up the stairs to the upper floor. Below, this heat is then missing, and above it gets warmer than planned. If your dining area is directly at the stairwell, plan a little more power there and keep the doors closed upstairs if the rooms there are not to be heated along with it.
One large radiator or two smaller ones
Both solutions can work. The differences are shown in the comparison:
| Criterion | One large radiator | Two smaller radiators |
|---|---|---|
| Heat distribution | good in compact rooms | better in long or L-shaped rooms |
| Connections | one connection point | two connection points required |
| Wall area | one large free wall | two smaller areas |
| Control | one thermostat | two thermostats, set equally |
| Appearance | quiet, one element | distributed, on two walls |
For a large radiator with a lot of power on a limited wall, a three-layer flat radiator like the KONRAD Type 33 is suitable. In 600 × 1400 mm, it delivers 3520 W at 75/65/20 °C. Keep in mind that three layers are deeper: the Type 33 is 160 mm deep, while the double-layer Type 22 is 105 mm.
If you prefer to distribute the heat, take two smaller models. The FJELLA Horizontal in white is 60 cm high and fits well under windows. In 60 × 122 cm, it delivers 1805 W at 75/65/20 °C. Two of them together provide a similar amount of heat to a large radiator, distributed across two locations.
Tip: Two radiators mean two connection points. If the pipes are only in one place, clarify with the professional heating company how much effort a second connection would require. This can influence the decision more than the appearance.
Correctly placing radiators in an open living area
There are some simple rules for the position:
- Radiators preferably where the most heat is lost: under windows or next to patio doors
- leave space in front of the radiator, no sofa and no sideboard directly in front
- weight the zones according to use: At the dining table and on the sofa you sit still for a long time
- in the kitchen do not rely on the heat from the stove and oven, it only occurs temporarily
- with floor-to-ceiling windows use a space next to them or choose a tall, narrow model
The power does not have to be distributed evenly. A dining table at a large window front needs more than an interior reading nook. Therefore, divide the total demand according to the window areas and exterior walls, not simply in half.
Suitable models for living spaces, from the flat valve radiator to the smooth panel front, you will find in our collection Living room radiators. What else you should pay attention to with flat radiators in the living room, you can read in Flat radiators in the living room. How heat distributes evenly at a fixed seat is also shown in our post on Radiators in the study.
Frequently Asked Questions
Do both radiators have to be the same size?
No. The size depends on the heat loss at the respective location. But identical models in the right width look calmer, especially if both are clearly visible.
Is one radiator sufficient if the kitchen is open?
That depends on the floor plan. The stove and oven only give off heat temporarily, you should not plan on that. If the kitchen is on an exterior wall with a window, it usually needs its own heating surface.
How do I set two thermostats in the same room?
Set both to the same level. If one radiator deviates significantly, one heats against the other. If one gets significantly warmer, a hydraulic balancing by the professional heating company can help.
What to do if there is no space under the windows?
Then use the wall next to the window, as close to the glass surface as possible. A tall, narrow model delivers a lot of heat there. A combination with underfloor heating is also possible, the professional company plans that.
Plan heat for the entire area
First calculate the heat demand for living, dining, and cooking together. Then distribute it among one or two radiators.


